LED setup

Total LEDs: ?
Recommended power supply for brightest white:
?
Global brightness factor: %
Enable automatic brightness limiter:
Automatically limits brightness to stay close to the limit.
Keep at <1A if powering LEDs directly from the ESP 5V pin!
If using multiple outputs it is recommended to use per-output limiter.
Analog (PWM) and virtual LEDs cannot use automatic brightness limiter.
Maximum PSU Current: mA
Use per-output limiter:

LED outputs:


LED memory usage: 0 / ? B

Show Advanced Settings
Make a segment for each output:
Custom bus start indices:
Color Order Override:

Color & White

Use Gamma correction for color: (strongly recommended)
Use Gamma correction for brightness: (not recommended)
Use Gamma value:

White Balance correction:
Global override for Auto-calculate white:
Calculate CCT from RGB:
CCT IC used (Athom 15W):
CCT blending (±100%): %
Positive: additive blend, Negative: exclusive blend
 ⚠ Set to 0 when using 2-wire (reverse polarity) CCT strips

Hardware setup

Buttons

Disable internal pull-up/down:
Touch threshold:

IR Remote

IR GPIO:  ✕
Apply IR change to main segment only:
IR info

Relay

Relay GPIO:  ✕
Invert Open drain

General settings

Power up

Turn LEDs on after power up/reset:
with brightness: (1-255)
(disable if using boot preset to turn LEDs on)

Apply preset at boot (0 = none)

Transitions

Default transition time: ms

Random Palettes

Use harmonic colors in Random palettes:
Random Palette Cycle Time: s

Timed light

Default duration: min
Default target brightness:
Mode:

Advanced

Palette wrapping:
Target refresh rate: FPS

Config template: