LED & Hardware setup

Total LEDs: ?
Recommended power supply for brightest white:
?
Enable automatic brightness limiter:
Automatically limits brightness to stay close to the limit.
Keep at <1A if powering LEDs directly from the ESP 5V pin!
If using multiple outputs it is recommended to use per-output limiter.
Analog (PWM) and virtual LEDs cannot use automatic brightness limiter.
Maximum PSU Current: mA
Use per-output limiter:

Hardware setup

LED outputs:

LED memory usage: 0 / ? B

Use parallel I2S:
Make a segment for each output:
Custom bus start indices:
Use global LED buffer:
Color Order Override:

Disable internal pull-up/down:
Touch threshold:
IR GPIO:  ✕
Apply IR change to main segment only:
IR info
Relay GPIO:  ✕
Invert Open drain

Defaults

Turn LEDs on after power up/reset:
Default brightness: (1-255)

Apply preset at boot (0 uses values from above)

Use Gamma correction for color: (strongly recommended)
Use Gamma correction for brightness: (not recommended)
Use Gamma value:

Brightness factor: %

Transitions

Default transition time: ms
Random Cycle Palette Time: s
Use harmonic Random Cycle Palette:

Timed light

Default duration: min
Default target brightness:
Mode:

White management

White Balance correction:
Global override for Auto-calculate white:

Calculate CCT from RGB:
CCT IC used (Athom 15W):
CCT additive blending: %
WARNING: When using H-bridge for reverse polarity (2-wire) CCT LED strip
make sure this value is 0.
(ESP32 variants only, ESP8266 does not support H-bridges)

Advanced

Palette wrapping:
Target refresh rate: FPS
Config template: