Integration discovered: rename Configure to Add to refelct current SW (#35393)

This commit is contained in:
c0ffeeca7 2024-10-26 06:17:53 +02:00 committed by GitHub
parent 1812254cdc
commit 1f94c91422
No known key found for this signature in database
GPG Key ID: B5690EEEBB952194
6 changed files with 3 additions and 3 deletions

View File

@ -17,7 +17,7 @@ This tutorial assumes that you have [installed Home Assistant](/installation/) a
![Screenshot of the integrations page, with discovered devices](/images/getting-started/integrations_page_discovered.png)
2. If there are any devices discovered for you, you can add them now.
- Under **Discovered**, on the integration, select **Configure**.
- Under **Discovered**, on the integration, select **Add**.
- Follow the steps in the UI if additional configuration is required.
- If no devices were discovered, don't worry, we will add an integration in the next step.
3. In the bottom-right corner, select **Add integration**.

Binary file not shown.

Before

Width:  |  Height:  |  Size: 17 KiB

After

Width:  |  Height:  |  Size: 15 KiB

Binary file not shown.

Before

Width:  |  Height:  |  Size: 20 KiB

After

Width:  |  Height:  |  Size: 21 KiB

Binary file not shown.

Before

Width:  |  Height:  |  Size: 170 KiB

After

Width:  |  Height:  |  Size: 170 KiB

View File

@ -75,7 +75,7 @@ This message indicates that the device could connect to the Wi-Fi, but is unable
2. Make sure your device is on the same network as Home Assistant.
- If you have a complex network setup with VLAN, make sure it is in the same VLAN.
3. Go to {% my integrations title="**Settings** > **Devices & Services**" %}.
- If the device is shown as **Discovered**, select **Configure**.
- If the device is shown as **Discovered**, select **Add**.
![ESP32-S3-BOX-3 open config file](/images/assist/esp32-discovered.png)
- If it was not discovered, select [**Add integration** > **ESPHome**](https://my.home-assistant.io/redirect/config_flow_start/?domain=esphome).
4. If you see the screen below, but the ESP32-S3-BOX-3 is not listed, select **Setup another instance of ESPHome**.

View File

@ -35,7 +35,7 @@ For the quickest way to get your local Assist pipeline started, follow these ste
- Once the add-ons are started, head over to the integrations under {% my integrations title="**Settings** > **Devices & Services**" %}.
- You should now see Piper and Whisper being discovered by the [Wyoming integration](/integrations/wyoming/).
![Whisper and Piper integrations](/images/assist/piper-whisper-install-new-02.png)
- For each integration, select **Configure**.
- For each integration, select **Add**.
- Once the setup is complete, you should see both Piper and Whisper (and, optionally, also openWakeword) in one integration.
![Whisper and Piper integration](/images/assist/piper-whisper-install-new-03.png)