diff --git a/source/_integrations/rflink.markdown b/source/_integrations/rflink.markdown
index 1837107611f..5f3127ac17e 100644
--- a/source/_integrations/rflink.markdown
+++ b/source/_integrations/rflink.markdown
@@ -16,17 +16,17 @@ ha_codeowners:
   - '@javicalle'
 ---
 
-The `rflink` integration supports devices that use [RFLink gateway firmware](http://www.rflink.nl/blog2/download), for example, the [Nodo RFLink Gateway](https://www.nodo-shop.nl/nl/21-rflink-gateway). RFLink Gateway is an Arduino Mega firmware that allows two-way communication with a multitude of RF wireless devices using cheap hardware (Arduino + transceiver).
+The `rflink` integration supports devices that use [RFLink gateway firmware](https://www.rflink.nl/download.php), for example, the [Nodo RFLink Gateway](https://www.nodo-shop.nl/nl/21-rflink-gateway). RFLink Gateway is an Arduino Mega firmware that allows two-way communication with a multitude of RF wireless devices using cheap hardware (Arduino + transceiver).
 
 The 433 MHz spectrum is used by many manufacturers mostly using their own protocol/standard and includes devices like: light switches, blinds, weather stations, alarms and various other sensors.
 
-RFLink Gateway supports a number of RF frequencies, using a wide range of low-cost hardware. [Their website](http://www.rflink.nl/blog2/) provides details for various RF transmitters, receivers and transceiver modules for 433MHz, 868MHz and 2.4 GHz.
+RFLink Gateway supports a number of RF frequencies, using a wide range of low-cost hardware. [Their website](https://www.rflink.nl) provides details for various RF transmitters, receivers and transceiver modules for 433MHz, 868MHz and 2.4 GHz.
 
 <div class='note'>
 Note: Versions later than R44 add support for Ikea Ansluta, Philips Living Colors Gen1 and MySensors devices.
 </div>
 
-A complete list of devices supported by RFLink can be found [here](http://www.rflink.nl/blog2/devlist).
+A complete list of devices supported by RFLink can be found [here](https://www.rflink.nl/devlist.php).
 
 This integration is tested with the following hardware/software:
 
@@ -69,7 +69,7 @@ tcp_keepalive_idle_timer:
   description: Time in seconds to wait since last data packet was seen before a TCP KEEPALIVE is sent. Value of 0 will disable this feature.
   required: false
   default: 3600
-  type: integer 
+  type: integer
 {% endconfiguration %}
 
 ### Full example
@@ -160,7 +160,7 @@ Even though a lot of devices are supported by RFLink, not all have been tested/i
 
 ### Device Incorrectly Identified
 
-If you find a device is recognized differently, with different protocols or the ON OFF is swapped or detected as two ON commands, it can  be overcome with the RFLink 'RF Signal Learning' mechanism from RFLink Rev 46 (11 March 2017). [Link to further detail.](http://www.rflink.nl/blog2/faq#RFFind)
+If you find a device is recognized differently, with different protocols or the ON OFF is swapped or detected as two ON commands, it can  be overcome with the RFLink 'RF Signal Learning' mechanism from RFLink Rev 46 (11 March 2017). [Link to further detail.](https://www.rflink.nl/faq.php#RFFind)
 
 ### Technical Overview