Add ha_release

source/_components/device_tracker.asuswrt.markdown

@@ -15,10 +15,6 @@ ha_release: pre 0.7
 
 The `asuswrt` platform offers presence detection by looking at connected devices to a [ASUSWRT](http://event.asus.com/2013/nw/ASUSWRT/) based router.
 
-<p class='note warning'>
-This device tracker needs telnet to be enabled on the router.
-</p>
-
 To use an ASUSWRT router in your installation, add the following to your `configuration.yaml` file:
 
 ```yaml
@@ -26,14 +22,20 @@ To use an ASUSWRT router in your installation, add the following to your `config
 device_tracker:
   platform: asuswrt
   host: YOUR_ROUTER_IP
+  protocol: telnet
   username: YOUR_ADMIN_USERNAME
   password: YOUR_ADMIN_PASSWORD
 ```
 
 Configuration variables:
 
-- **host** (*Required*): The IP address of your router, e.g. 192.168.1.1.
+- **host** (*Required*): The IP address of your router, eg. 192.168.1.1.
+- **protocol** (*Optional*): The protocol (`ssh` or `telnet`) to use. Defaults to `ssh`.
 - **username** (*Required*: The username of an user with administrative privileges, usually *admin*.
 - **password** (*Required*): The password for your given admin account.
 
+<p class='note warning'>
+You need to enable telnet on your router if you choose to use `protocol: telnet`. 
+</p>
+
 See the [device tracker component page](/components/device_tracker/) for instructions how to configure the people to be tracked.

source/_components/sensor.nest.markdown

@@ -9,6 +9,7 @@ sharing: true
 footer: true
 logo: nest_thermostat.png
 ha_category: Sensor
+ha_release: pre 0.7
 ---
 
 
@@ -59,4 +60,7 @@ Configuration variables:
   - 'wind_direction'
   - 'co_status' # Nest Protect only
   - 'smoke_status' # Nest Protect only
-<p class='note'>You must have the [Nest component](/components/nest/) configured to use this sensor.</p>
+
+<p class='note'>
+You must have the [Nest component](/components/nest/) configured to use this sensor.
+</p>