Update sensor.apcupsd docs to reflect changes (#617)

* Update sensor.apcupsd docs to reflect changes

* Remove "type:" from configuration

source/_components/sensor.apcupsd.markdown

@@ -11,11 +11,30 @@ logo: apcupsd.png
 ha_category: Sensor
 ---
 
-Any of the lines of output from the [apcaccess](http://linux.die.net/man/8/apcaccess) command can be used as a sensor device in Home Assistant. In order to create a sensor for a value, create an entity within a `sensor` section of your configuration. The following parameters may be used:
+The `apcupsd` sensor platform to allow you to monitor a UPS (battery backup) by using data from the [apcaccess](http://linux.die.net/man/8/apcaccess) command.
 
-- **name** (*Required*): The name you'd like to give the sensor in Home Assistant.
+To add this platform to your installation, add the following to your `configuration.yaml` file:
-- **platform** (*Required*): Set to `apcupsd`.
+
-- **type** (*Required*): The label for the value you'd like to track based on the output of `apcaccess`. Refer to the examples for ideas.
+```yaml
+# Example configuration.yaml entry
+sensor:
+  - platform: apcupsd
+    resources:
+      - bcharge
+      - linev
+      - loadpct
+      - nominv
+      - nompower
+      - numxfers
+      - outputv
+      - status
+      - timeleft
+      - tonbatt
+```
+
+Configuration variables:
+
+- **resources** array (*Required*): Contains all entries to display.
 
 #### Example
 
@@ -76,19 +95,13 @@ FIRMWARE : 70.11.I
 END APC  : 2016-02-09 17:13:46 +0000
 ```
 
-Use the (case insensitive) values from the left hand column as your `type`:
+Use the (case insensitive) values from the left hand column:
 
 ```yaml
 sensor:
-  - name: Mains Voltage
+  - platform: apcupsd
-    platform: apcupsd
+    resources:
-    type: linev
+      - linev
-
+      - loadpct
-  - name: UPS Load
+      - itemp
-    platform: apcupsd
-    type: loadpct
-
-  - name: UPS Temperature
-    platform: apcupsd
-    type: itemp
 ```