From 645b89dac776dc4bc6df2a81361ca00afcb2520e Mon Sep 17 00:00:00 2001 From: David Bonnes Date: Tue, 1 Oct 2019 14:22:24 +0100 Subject: [PATCH] small tweaks (#10494) --- source/_components/incomfort.markdown | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/source/_components/incomfort.markdown b/source/_components/incomfort.markdown index 57748c30438..40b9743e5da 100644 --- a/source/_components/incomfort.markdown +++ b/source/_components/incomfort.markdown @@ -21,11 +21,11 @@ The boiler is represented as a **Water Heater** device. It will report the boile Note that the `current_temperature` will switch between the CV (circulating volume) and Tap temperatures according to the current operating mode of the boiler. If the boiler is neither pumping nor tapping, it will be reported as the higher of the two. -In addition, there is a **Sensor** for CV pressure, CV temperature, and Tap temperature, and a **Binary Sensor** that will be `on` if there is a fault with the boiler (the fault code will be a state attribute). +In addition, there is a **Sensor** for each of CV pressure, CV temperature, and Tap temperature, and a **Binary Sensor** that will be `on` if there is a fault with the boiler (the fault code will be a state attribute). ### Rooms -Any room thermostats (there can be 0, 1 or 2) are represented as **Climate** devices. They will report the thermostat's `temperature` (setpoint) and `current_temperature` and the setpoint can be changed. +Any room thermostats (there can be 0, 1 or 2) are represented as **Climate** devices. They will report the thermostat's `temperature` (setpoint, target temperature) and `current_temperature` and the setpoint can be changed. ## Automation @@ -52,9 +52,9 @@ Other properties are available via each device's attributes. ## Configuration -To set up this integration, add the following to your **configuration.yaml** file: +To set up this integration, add one of the following to your **configuration.yaml** file: -The hub does not have to be in the same network as HA. +The hub does not have to be in the same network as HA, but must be reachable via port 80/HTTP. ### Older gateways