diff --git a/source/_includes/esphome/flash_firmware_steps.markdown b/source/_includes/esphome/flash_firmware_steps.markdown
index e6dbdff4519..8d0d80974f9 100644
--- a/source/_includes/esphome/flash_firmware_steps.markdown
+++ b/source/_includes/esphome/flash_firmware_steps.markdown
@@ -11,19 +11,19 @@
 1. Select your device, then **Install**.
      * Follow the instructions provided by the installation wizard.
      * Add the device to your Wi-Fi:
-     * When prompted, select your network from the list and enter the credentials to your 2.4 GHz Wi-Fi network.
-     * Select **Connect**.
-     * The device now joined your network. Select **Add to Home Assistant**.
-1. This opens the **My** link to Home Assistant. 
+       * When prompted, select your network from the list and enter the credentials to your 2.4 GHz Wi-Fi network.
+       * Select **Connect**.
+       * The device now joined your network. Select **Add to Home Assistant**.
+2. This opens the **My** link to Home Assistant. 
    * If you have not used My Home Assistant before, you will need to configure it. If your Home Assistant URL is not accessible on `http://homeassistant.local:8123`, replace it with the URL to your Home Assistant instance.
    * Open the link.
    ![Open My link](/images/assist/esp32-atom-flash-06.png)
-1. Select **OK**. 
+3. Select **OK**. 
    
    ![Set up ESPHome](/images/assist/esp32-atom-flash-07.png)
-1. To add the newly discovered device, select the device from the list.
+4. To add the newly discovered device, select the device from the list.
    * Add your device to a room and select **Finish**. 
-1. You should now see a new integration.
+5. You should now see a new integration.
 
    ![Device discovered](/images/assist/m5stack-atom-echo-discovered-03.png)
    * Your device is connected to Home Assistant over Wi-Fi. You can now move it to any place in your home with a USB power supply. 
\ No newline at end of file