mirror of
https://github.com/home-assistant/home-assistant.io.git
synced 2025-07-15 21:36:52 +00:00
Update the docs for the Xiaomi Gateway component (#8890)
* Update the docs * Fix typos * Fix typos * Remove the unnecessary last step
This commit is contained in:
parent
5ed9c98da7
commit
91f2dd7657
@ -277,3 +277,14 @@ That means that Home Assistant is not getting any response from your Xiaomi gate
|
||||
- You should generate the key again using an Android Phone or alternatively an emulator such as [bluestacks](https://www.bluestacks.com). In some instances, there is an issue with keys being generated using the iOS application.
|
||||
- You need to make sure to have multicast support on your network. If you are running Home Assistant in a virtual machine (like Proxmox), try `echo 0 >/sys/class/net/vmbr0/bridge/multicast_snooping` on the host and restart the service or reboot the host.
|
||||
- If the required library "PyXiaomiGateway" cannot be installed you will need to install some missing system dependencies `python3-dev`, `libssl-dev`, `libffi-dev` manually (e.g., `$ sudo apt-get install python3-dev libssl-dev libffi-dev`).
|
||||
- If your gateway's MAC address starts with `04:CF:8C`, there is a good chance that the required port `9898` is closed on your gateway (you can check it with the Nmap utility, using the command `sudo nmap - sU {gateway_ip} -p 9898`). To fix that issue, you need to do these steps:
|
||||
- Find a specific screw bit (like a fork) to open the gateway case.
|
||||
- Find a USB-UART cable/module and connect it to your computer.
|
||||
- Solder 3 wires - RX, TX and GND like [here](http://cs5-3.4pda.to/14176168/IMG_20181020_201150.jpg).
|
||||
- Turn on the gateway (220V).
|
||||
- Open a serial terminal application (e.g. PuTTY) and connect to the serial port assigned to the USB-UART module (baudrate: 115200).
|
||||
- Wait until the gateway is booted up, connect the RX, TX and GND wires to the UART module (don't connect the Vcc (power) wire!).
|
||||
- You will see all the messages from the gateway.
|
||||
- Send the command `psm-set network.open_pf 3` (the command has to end with a `CR` newline character).
|
||||
- Check your settings executing the command `psm-get network.open_pf` to be sure it's OK.
|
||||
- Restart the gateway.
|
||||
|
Loading…
x
Reference in New Issue
Block a user