diff --git a/source/_integrations/homewizard.markdown b/source/_integrations/homewizard.markdown index c3dbaabcf38..22ff31ee34b 100644 --- a/source/_integrations/homewizard.markdown +++ b/source/_integrations/homewizard.markdown @@ -13,6 +13,7 @@ ha_platforms: - button - diagnostics - number + - select - sensor - switch ha_zeroconf: true @@ -118,6 +119,16 @@ The Energy Socket also has a switch to control the outlet state and a status lig - **Cycles**: Number of charge cycles the battery has gone through. - **State of charge (%)**: The current state of charge of the battery. +#### Battery group mode + +The group of connected batteries can be controlled in three different modes using the **Battery group mode** select entity: + +- **Zero on meter**: The Plug-In Battery will try to keep the power consumption/production of your home at zero. This means that the Plug-In Battery will charge or discharge to maintain a net-zero power balance. This is the default mode. +- **Charge to full**: All connected Plug-In Batteries will be charged to 100%, regardless of the power consumption/production of your home. When all batteries are fully charged, the Plug-In Battery will switch to the standby mode. +- **Standby**: Batteries will enter standby mode. This means that the Plug-In Battery will neither charge nor discharge. + +The **Battery group mode** select can be found in the P1 Meter device, as the P1 Meter is responsible for controlling the Plug-In Battery. This select entity is disabled by default. See [I can't find entities](#i-cant-find-entities-like-voltage-current-or-battery-group-mode) for instructions on enabling disabled entities. + ## Identify The identify button can be pressed to let the status light blink for a few seconds. @@ -177,9 +188,9 @@ It may happen that you can't find your devices or they won't show up in the inte 2. After pressing the button, you must select **Continue** within 30 seconds to complete the setup. - If the setup times out, you may need to press the button again. -## I can't find sensors like voltage, current, or frequency +## I can't find entities like voltage, current, or battery group mode -Some sensors are disabled by default. You can enable them in the integration setup. See the [enabling or disabling entities](/common-tasks/general/#enabling-or-disabling-entities) documentation for more information. +Some entities are disabled by default. You can enable them in the integration setup. See the [enabling or disabling entities](/common-tasks/general/#enabling-or-disabling-entities) documentation for more information. ## Removing the integration