From 65b07a560901855ff477b3330453abb3eadc95c5 Mon Sep 17 00:00:00 2001 From: sfam Date: Fri, 15 Jan 2016 22:52:44 +0000 Subject: [PATCH] Update and rename sensor.rpi_gpio.markdown to binary_sensor.rpi_gpio.markdown reflect changes from https://github.com/balloob/home-assistant/pull/899 --- ...pio.markdown => binary_sensor.rpi_gpio.markdown} | 13 ++++++------- 1 file changed, 6 insertions(+), 7 deletions(-) rename source/_components/{sensor.rpi_gpio.markdown => binary_sensor.rpi_gpio.markdown} (73%) diff --git a/source/_components/sensor.rpi_gpio.markdown b/source/_components/binary_sensor.rpi_gpio.markdown similarity index 73% rename from source/_components/sensor.rpi_gpio.markdown rename to source/_components/binary_sensor.rpi_gpio.markdown index 4d4ade557fa..98e5f967c13 100644 --- a/source/_components/sensor.rpi_gpio.markdown +++ b/source/_components/binary_sensor.rpi_gpio.markdown @@ -12,30 +12,29 @@ ha_category: DIY --- -The rpi_gpio sensor platform allows you to read sensor values of the GPIOs of your [Raspberry Pi](https://www.raspberrypi.org/). +The rpi_gpio binary sensor platform allows you to read sensor values of the GPIOs of your [Raspberry Pi](https://www.raspberrypi.org/). To use your Raspberry Pi's GPIO in your installation, add the following to your `configuration.yaml` file: ```yaml # Example configuration.yaml entry -sensor: +binary_sensor: platform: rpi_gpio ports: 11: PIR Office 12: PIR Bedroom pull_mode: "UP" - value_high: "Active" - value_low: "Inactive" + bouncetime: 50 + invert_logic: false ``` Configuration variables: - **ports** array (*Required*): Array of used ports. - - **port: name** (*Required*): Your username for the Edimax switch. + - **port: name** (*Required*): Port numbers and corresponding names. - **pull_mode** (*Optional*): The internal pull to use (UP or DOWN). Default is UP. -- **value_high** (*Optional*): The value of the sensor when the port is HIGH. Default is "HIGH". -- **value_low** (*Optional*): The value of the sensor when the port is LOW. Default is "LOW". - **bouncetime** (*Optional*): The time in milliseconds for port debouncing. Default is 50ms. +- **invert_logic** (*Optional*): If true, inverts the output logic to ACTIVE LOW. Default is false (ACTIVE HIGH). For more details about the GPIO layout, visit the Wikipedia [article](https://en.wikipedia.org/wiki/Raspberry_Pi#GPIO_connector) about the Raspberry Pi.