---
title: "Raspberry Pi integrations"
description: "Home Assistant integrations specific to the Raspberry Pi."
redirect_from: /docs/hassbian/integrations/
---

Some integrations that are specific for the Raspberry Pi can require some further configuration outside of Home Assistant. All commands below are assumed to be executed with the `pi` account. For full documentation of these integrations refer to the [integrations](/components) page.

### Bluetooth Tracker

The Bluetooth tracker will work on a Raspberry Pi 3 with the built-in Bluetooth module or with a USB Bluetooth device on any of the other Raspberry Pi's.

Software needed for the tracker is pre-installed so just follow the [Bluetooth Tracker integration](/components/bluetooth_tracker/) and [Device Tracker page](/components/device_tracker/) pages.

### Raspberry Pi GPIO

Each of the following devices are connected to the GPIO pins on the Raspberry Pi.
For more details about the GPIO layout, visit the [documentation](https://www.raspberrypi.org/documentation/usage/gpio/) from the Raspberry Pi foundation.

Permission have been given to the `homeassistant` user to use the GPIO pins and all of the following integrations should require no underlying changes to work.
Just follow the integration pages for each on how to add them to your Home Assistant installation.

 - [DHT Sensor](/components/dht/)
 - [Raspberry Pi Cover](/components/rpi_gpio/#cover)
 - [Raspberry Pi GPIO Binary Sensor](/components/rpi_gpio/#binary-sensor)
 - [Raspberry Pi GPIO Switch](/components/rpi_gpio/#switch)
 - [Raspberry Pi RF Switch](/components/rpi_rf/)

### Raspberry Pi Camera

The Raspberry Pi Camera is a specific camera for the Raspberry Pi boards. For more information about the camera I suggest reading the [documentation](https://www.raspberrypi.org/documentation/usage/camera/) from the Raspberry Pi foundation.

To use the camera it needs to be enabled with the `raspi-config` utility.

```bash
$ sudo raspi-config
```

Go to `Interfacing Options`, select `Enable camera` choose `<Yes>` and hit `Enter`, then go to `Finish` and you'll be prompted to reboot.

After this follow the [Raspberry Pi Camera integration](/components/rpi_camera/) page.

### One wire Sensor

The One wire sensor requires that support for it is enabled on the Raspberry Pi and that the One Wire device is connected to GPIO pin 4.
To enable One Wire support add the following line to the end of `/boot/config.txt`
```yaml
dtoverlay=w1-gpio
```
After this follow the [One Wire Sensor integration](/components/onewire/) page.