---
title: BeagleBone Black GPIO
description: Instructions on how to integrate the GPIO capability of a BeagleBone Black into Home Assistant.
ha_category:
  - DIY
  - Binary Sensor
  - Switch
ha_release: 0.36
ha_iot_class: Local Push
ha_domain: bbb_gpio
ha_platforms:
  - binary_sensor
  - switch
---

<div class='note warning'>

This integration is deprecated and will be removed in Home Assistant Core 2022.4.

For more information see: [Architectural Decision Record 0019](https://github.com/home-assistant/architecture/blob/master/adr/0019-GPIO.md).

</div>

The `bbb_gpio` integration is the base for all [BeagleBone Black](https://beagleboard.org/black) related GPIO platforms in Home Assistant.
There is no setup needed for the integration itself.

## Binary Sensor

The `bbb_gpio` binary sensor platform allows you to read sensor values of the GPIOs of your [BeagleBone Black](https://beagleboard.org/black).

### Configuration

To use your BeagleBone Black's GPIO in your installation, add the following to your `configuration.yaml` file:

```yaml
# Example configuration.yaml entry
binary_sensor:
  - platform: bbb_gpio
    pins:
      P8_12:
        name: Door
      GPIO0_26:
        name: Window
```

{% configuration %}
pins:
  description: List of used pins.
  required: true
  type: map
  keys:
    pin_name:
      description: Port numbers and corresponding names.
      required: true
      type: map
      keys:
        name:
          description: Friendly name to use for the frontend.
          required: true
          type: string
        bouncetime:
          description: Debounce time for reading input pin defined in milliseconds [ms].
          required: false
          type: integer
          default: 50
        invert_logic:
          description: If `true`, inverts the input logic to ACTIVE LOW
          required: false
          type: boolean
          default: false
        pull_mode:
          description: Type of internal pull resistor connected to input. Options are `UP` - pull-up resistor and `DOWN` - pull-down resistor.
          required: false
          type: string
          default: UP
{% endconfiguration %}

For more details about the GPIO layout, visit the [article](https://elinux.org/Beagleboard:BeagleBoneBlack) about the BeagleBone Black.

## Switch

The `bbb_gpio` switch platform allows you to control the GPIOs of your [BeagleBone Black](https://beagleboard.org/black).

### Configuration

To use your BeagleBone Black's GPIO in your installation, add the following to your `configuration.yaml` file:

```yaml
# Example configuration.yaml entry
switch:
  - platform: bbb_gpio
    pins:
      GPIO0_7:
        name: LED Red
      P9_12:
        name: LED Green
```

{% configuration %}
pins:
  description: List of used pins.
  required: true
  type: map
  keys:
    pin_name:
      description: Port numbers and corresponding names.
      required: true
      type: map
      keys:
        name:
          description: Friendly name to use for the frontend.
          required: false
          type: string
        initial:
          description: Initial state of the pin.
          required: false
          default: false
          type: boolean
        invert_logic:
          description: If `true`, inverts the input logic to ACTIVE LOW
          required: false
          default: false
          type: boolean
{% endconfiguration %}

For more details about the GPIO layout, visit the [article](https://elinux.org/Beagleboard:BeagleBoneBlack) about the BeagleBone Black.