From e61246f5ba5b44ebebca48482bfcf1969b04cc94 Mon Sep 17 00:00:00 2001 From: Stefan Agner Date: Mon, 25 Apr 2022 14:58:12 +0200 Subject: [PATCH] Cleanup Yellow config.txt (#1865) --- .../board/raspberrypi/yellow/config.txt | 47 ++----------------- 1 file changed, 3 insertions(+), 44 deletions(-) diff --git a/buildroot-external/board/raspberrypi/yellow/config.txt b/buildroot-external/board/raspberrypi/yellow/config.txt index ff6a4374f..0595e6f8c 100644 --- a/buildroot-external/board/raspberrypi/yellow/config.txt +++ b/buildroot-external/board/raspberrypi/yellow/config.txt @@ -10,45 +10,9 @@ arm_64bit=1 # uncomment to enable primary UART console enable_uart=1 -# uncomment if you get no picture on HDMI for a default "safe" mode -#hdmi_safe=1 - -# uncomment this if your display has a black border of unused pixels visible -# and your display can output without overscan -#disable_overscan=1 - -# uncomment the following to adjust overscan. Use positive numbers if console -# goes off screen, and negative if there is too much border -#overscan_left=16 -#overscan_right=16 -#overscan_top=16 -#overscan_bottom=16 - -# uncomment to force a console size. By default it will be display's size minus -# overscan. -#framebuffer_width=1280 -#framebuffer_height=720 - -# uncomment if hdmi display is not detected and composite is being output -#hdmi_force_hotplug=1 - -# uncomment to force a specific HDMI mode (this will force VGA) -#hdmi_group=1 -#hdmi_mode=1 - -# uncomment to force a HDMI mode rather than DVI. This can make audio work in -# DMT (computer monitor) modes -#hdmi_drive=2 - -# uncomment to increase signal to HDMI, if you have interference, blanking, or -# no display -#config_hdmi_boost=4 - -# uncomment for composite PAL -#sdtv_mode=2 - -# Uncomment to disable continous SD-card poll (for USB SSD) -#dtparam=sd_poll_once=on +# No HDMI on Yellow, but we can't set to 16 since we need the full firmware +# for codecs +gpu_mem=32 # Uncomment some or all of these to enable the optional hardware interfaces #dtparam=i2c_arm=on @@ -66,11 +30,6 @@ enable_uart=1 # Additional overlays and parameters are documented /boot/overlays/README -# Enable audio (loads snd_bcm2835) -dtparam=audio=on - [all] -#dtoverlay=vc4-fkms-v3d -#max_framebuffers=2 device_tree=bcm2711-rpi-cm4-ha-yellow.dtb