* Make it clearer that the image file needs to be renamed
- add information that the update was only successful if version 20230328 is visible.
* Update Documentation/boards/hardkernel/odroid-m1.md
---------
Co-authored-by: Stefan Agner <stefan@agner.ch>
* buildroot 8e1c933e7f...21edbd975f (4):
> package/docker-cli: bump version to v23.0.6
> package/docker-engine: bump version to v23.0.6
> package/containerd: Bump to containerd 1.6.21
> package/runc: bump to version 1.1.7
With U-Boot 2023.01 booting on Raspberry Pi 4 32-bit (at least with 4
or 8GB of memory) freezes when trying to enumerate USB devices. It seems
that the PCIe initialization partially fails, which causes the USB XHCI
initialization to fail.
It seems that a new restriction on viable addresses for PCIe
initialization causes the problem. Revert the offending commit to make
U-Boot properly detect USB devices again.
The new U-Boot 2023.01 requires an additional config which is missing
from the generic Raspberry Pi U-Boot configuration (see #2234). Add
it to the generic Raspberry Pi U-Boot configuration so Yellow as well as
other CM4 based systems can boot from NVMe SSD again.
* buildroot befb515cdb...ddc0ddca51 (4):
> package/docker-cli: bump version to v23.0.3
> package/docker-engine: security bump version to v23.0.3
> package/containerd: security bump to version 1.6.20
> package/runc: security bump to version v1.1.5
* Enable Multi-Gen LRU
Multi-Gen LRU should improve performance under memory pressure. This is
especially useful for embedded platforms where memory is scarce.
* Add service to configure Multi-Gen LRU
Use min_ttl_ms of 1 which is the least aggressive in terms of lag. Since
we are a server application, we can tune trashing prevention with a
higher acceptable lag.
* Add multiple routes support in NetworkManager
Support multiple routes to the same network learned via Router
Information Option. With this change, the kernel will have multiple
routing table entries to a given Thread network. The routes gateway
won't be updated with every new RIO any longer since every gateway
has its own entry.
* Enable IPv6 router reachability probing
Currently router reachability probing is disabled since HAOS enables
IPv6 forwarding and the necessary kernel options are not enabled. With
this change router reachability probing is enabled even though we are
a router on our own.
Note that Linux commit ea659e077528 ("[IPV6] ROUTE: Do not enable router
reachability probing in router mode.") by default disabled this
behavior. But since we are acting as a router as well as a host device,
we rather want this reachability probing.
See also: https://lore.kernel.org/netdev/b9182b02829b158d55acc53a0bcec1ed667b2668.1680000784.git.stefan@agner.ch/T/#u
