mirror of
https://github.com/home-assistant/home-assistant.io.git
synced 2025-06-01 15:56:49 +00:00
57 lines
2.7 KiB
Markdown
57 lines
2.7 KiB
Markdown
---
|
|
layout: page
|
|
title: "Raspberry Pi integrations"
|
|
description: "Home Assistant integrations specific to the Raspberry Pi."
|
|
date: 2016-09-26 21:00
|
|
sidebar: true
|
|
comments: false
|
|
sharing: true
|
|
footer: true
|
|
redirect_from: /getting-started/hassbian-installation/
|
|
---
|
|
|
|
Some components that are specific for the Raspberry Pi can require some further configuration outside of Home Assistant. All commands below are assumed to be executed with the `pi` account. For full documentation of these components refer to the [components](/components) page.
|
|
|
|
### {% linkable_title Bluetooth Tracker %}
|
|
|
|
The Bluetooth tracker will work on a Raspberry Pi 3 with the built-in Bluetooth module or with a USB Bluetooth device on any of the other Raspberry Pi's.
|
|
|
|
Software needed for the tracker is pre-installed so just follow the [Bluetooth Tracker component](/components/device_tracker.bluetooth_tracker/) and [Device Tracker page](/components/device_tracker/) pages.
|
|
|
|
### {% linkable_title Raspberry Pi GPIO %}
|
|
|
|
Each of the following devices are connected to the GPIO pins on the Raspberry Pi.
|
|
For more details about the GPIO layout, visit the [documentation](https://www.raspberrypi.org/documentation/usage/gpio/) from the Raspberry Pi foundation.
|
|
|
|
Permission have been given to the `homeassistant` user to use the GPIO pins and all of the following components should require no underlying changes to work.
|
|
Just follow the component pages for each on how to add them to your Home Assistant installation.
|
|
|
|
- [DHT Sensor](/components/sensor.dht/).
|
|
- [Raspberry Pi Cover](/components/cover.rpi_gpio/).
|
|
- [Raspberry PI GPIO Binary Sensor](/components/binary_sensor.rpi_gpio/).
|
|
- [Raspberry PI GPIO Switch](/components/switch.rpi_gpio/).
|
|
- [Raspberry Pi RF Switch](/components/switch.rpi_rf/).
|
|
|
|
### {% linkable_title Raspberry Pi Camera %}
|
|
|
|
The Raspberry Pi Camera is a specific camera for the Raspberry Pi boards. For more information about the camera I suggest reading the [documentation](https://www.raspberrypi.org/documentation/usage/camera/) from the Raspberry Pi foundation.
|
|
|
|
To use the camera it needs to be enabled with the `raspi-config` utility.
|
|
|
|
```bash
|
|
$ sudo raspi-config
|
|
```
|
|
|
|
Select `Enable camera` choose `<Yes>` and hit `Enter`, then go to `Finish` and you'll be prompted to reboot.
|
|
|
|
After this follow the [Raspberry Pi Camera component](/components/camera.rpi_camera/) page.
|
|
|
|
### {% linkable_title One wire Sensor %}
|
|
|
|
The One wire sensor requires that support for it is enabled on the Raspberry Pi and that the One Wire device is connected to GPIO pin 4.
|
|
To enable One Wire support add the following line to the end of `/boot/config.txt`
|
|
```yaml
|
|
dtoverlay=w1-gpio
|
|
```
|
|
After this follow the [One Wire Sensor component](/components/sensor.onewire/) page.
|