home-assistant.io/source/_components/mysensors.markdown

layout, title, description, date, sidebar, comments, sharing, footer, logo, ha_category, featured

layout	title	description	date	sidebar	comments	sharing	footer	logo	ha_category	featured
page	MySensors	Instructions how to integrate MySensors sensors into Home Assistant.	2016-02-15 17:37 +0100	true	false	true	true	mysensors.png	Hub	true

The MySensors project combines Arduino boards with NRF24L01 radio boards to build sensor networks. The component will automatically add all available devices to Home Assistant, after presentation is done.

{% linkable_title Configuration %}

Integrate your Serial MySensors Gateway by adding the following to your configuration.yaml file:

# Example configuration.yaml entry
mysensors:
  gateways:
    - port: '/dev/ttyUSB0'
      persistence_file: 'path/mysensors.json'
      baud_rate: 38400
    - port: '/dev/ttyACM1'
      persistence_file: 'path/mysensors2.json'
      baud_rate: 115200
  debug: true
  persistence: true
  version: '1.5'

Configuration variables:

• port (Required): The port where your board is connected to your Home Assistant host.
• debug (Optional): Enable or disable verbose debug logging. Default is false.
• persistence (Optional): Enable or disable local persistence of sensor information. If this is disabled, then each sensor will need to send presentation messages after Home Assistant starts. Default is true.
• persistence_file (Optional): Path to a file to save sensor information. The file extension determines the file type. Currently supported file types are 'pickle' and 'json'.
• version (Optional): Specifies the MySensors protocol version to use. Supports 1.4 and 1.5. Default is 1.4.
• baud_rate (Optional): Specifies baud rate of the connected gateway. Default is 115200.

If you are using an original Arduino the port will be named ttyACM*. The exact number can be determined with the command shown below.

$ ls /dev/ttyACM*

{% linkable_title Presentation %}

Present a MySensors sensor or actuator, by following these steps:

1. Connect your gateway to your computer.
2. Configure the MySensors component in configuration.yaml.
3. Start hass.
4. Wait for "gateway started" in the log output.
5. Write and upload your MySensors sketch to the sensor. Make sure you:
   • Either use a manual node id, or AUTO for requesting a node id from the controller, in gw.begin().
   • Send sketch name.
   • Present the sensor's S_TYPE.
   • Send at least one initial value per V_TYPE.
6. Start the sensor.

Visit the library api of MySensors for more information.