3.2 KiB
title, description
| title | description |
|---|---|
| HomeMatic | HomeMatic hardware support to turn Home Assistant into a CCU. |
You can't import an existing configuration, you'll need re-learn it into Home Assistant. There is an experimental WebUI alias Regahss support since 9.0. Before it was required to use a third-party tool.
Follow devices will be supported and tested:
{
"rf_enable": true,
"rf": [
{
"type": "CCU2",
"device": "/dev/ttyAMA0"
}
],
"wired_enable": false,
"wired": [
{
"serial": "xy",
"key": "abc",
"ip": "192.168.0.0"
}
],
"hmip_enable": false,
"hmip": [
{
"type": "HMIP_CCU2",
"device": "/dev/ttyUSB0"
}
]
}
{% configuration %} rf_enable: description: Enable or disable BidCoS-RF. required: true type: boolean default: false rf: description: RF devices. required: true type: list keys: type: description: Device type for RFD service. Look into the manual of your device. required: true type: string device: description: Device on the host. required: true type: string wired_enable: description: Enable or disable BidCoS-Wired. required: true type: boolean default: false wired: description: Wired devices. required: true type: list keys: serial: description: Serial number of the device. required: true type: string key: description: The encrypted key. required: true type: string ip: description: The IP address of LAN gateway. required: true type: string hmip_enable: description: Enable or disable hmip. required: true type: boolean default: false hmip: description: HMIP devices. required: true type: list keys: type: description: Device type for RFD service. Look into the manual of your device. required: true type: string device: description: Device on the host. required: true type: string {% endconfiguration %}
Home Assistant configuration
Use the following configuration in Home Assistant to use it:
homematic:
interfaces:
rf:
host: core-homematic
port: 2001
wired:
host: core-homematic
port: 2000
hmip:
host: core-homematic
port: 2010
Raspberry Pi3
With HM-MOD-RPI-PCB you need to add follow into your config.txt on boot partition:
dtoverlay=pi3-miniuart-bt
HmIP-RFUSB
HassOS > 1.11 support HmIP-RFUSB by default and don't need any configuration. If you run a Linux installation, you need to follow the installation guide from the documentation to set up the UART USB interface on your computer.
Web UI
To enable the experimental WebUI for built-in CCU specify a port number for "Regahss Webinterface" on the addon configuration page under the network section. After saving the changes, click on the "Open Web UI" button and proceed with the Homematic WebUI configuration.